nomadtechno.blogg.se - Canon usa manual for pixma mp990

#Canon usa manual for pixma mp990 mac os x#
#Canon usa manual for pixma mp990 drivers#
#Canon usa manual for pixma mp990 software#

#Canon usa manual for pixma mp990 mac os x#

Mac OS 9, Mac OS X Classic environments, or Mac OS X v.10.3.8 or earlier are not supported.

#Canon usa manual for pixma mp990 software#

If such a warning message appears, set the security software to always allow access. If the firewall function of your security software is turned on, a warning message may appear that Canon software is attempting to access the network. The installation resumes once your computer has restarted. Follow the on-screen instructions and do not remove the Setup CD-ROM during restarting. It may be necessary to restart your computer during the installation process.Internet connection may be required during the installation.Do not switch users during the installation process.Log on as the administrator (or a member of the Administrators group).Quit all running applications before installation. The screens below are based on Mac OS X v.10.5.x. (The installation time varies depending on the computer environment or the number of applications to be installed.) The installation process takes about 20 minutes.

#Canon usa manual for pixma mp990 drivers#

To use the machine by connecting it to a computer, software including the drivers needs to be copied (installed) to the computer's hard disk. When the completion screen appears, press the button, then press the button (C).* Select Hexadecimal when it is 64 characters (digits). * Select Characters when the network key is 8 or 63 characters. Make sure that the network key is correct, then press the button.Letters are not case sensitive if the format is hexadecimal. Note: Enter upper and lower case letters of the alphabet correctly when the key input format is characters.

Use the button to move the cursor to the right, then press the button.

Use the Easy-Scroll Wheel to enter the network key (select the character).

Selecting other key numbers will disable the connection between the machine and AirPort. Note: When using AirPort, select WEP key 1 in the screen.

Select the WEP key number you want to use, then press the button.

* Select Hexadecimal when it is 10 or 28 characters (digits).

* Select Characters when the network key is 5 or 13 characters. * When WEP (Transitional Security Network) is selected in AirPort Utility, select WEP (128 bit) or WPA2-PSK (AES). * When WEP 40 bit is selected in AirPort Utility (AirPort Admin Utility), select WEP (64 bit).

Select a security protocol for the access point, then press the button.

When using multiple access points, select Use multiple APs and then go to step 7.

Select the MAC address of the target access point and then go to step 7.

When you have only one access point, select Use one AP only.

When multiple access points with the same name are found, select the appropriate function to proceed through the installation. * The access point names with 2-byte characters are not displayed properly, however, can be selected. * If you are living in an apartment, nearby access points in use may be detected.

Select the access point name you wrote down, then press the button.

When wireless connection is enabled, the Wi-Fi lamp (B) lights blue.

Use the Easy-Scroll Wheel (A) to select Settings, then press the button.Wireless LAN setup - Multiple Access Points, Single SSID Use these instructions if your network has multiple AirPort Networking Devices (including Time Capsule, AirPort Extreme, AirPort Express, etc.) For example: AirPort Extreme AND Time Capsule.